Ground Branch Build 14724463 -

I’m unable to generate a verified or official report for “Ground Branch Build 14724463” because that specific build number does not correspond to any publicly documented release from the developers (Microprox or the Ground Branch team) as of my current knowledge.

Which route would you like?

7 thoughts on “From Zero to NOOBS: Starting with Raspberry Pi Zero”

Richard Greatorex on December 12, 2015 at 20:09 said:

© 2026 Smart Gate. All rights reserved.

For USB to micro conversion, I use these inserts:

http://www.ebay.co.uk/itm/DM-OTG-Adapter-Micro-USB-Male-to-USB-Female-For-Samsung-Android-Phone-Tablet-PC-/391313051444?hash=item5b1c134f34:g:ax4AAOSwT6pV6lM3

The only problem, due to their size, is that they are easy to lose.

LikeLike

Reply ↓
- Erich Styger on December 12, 2015 at 20:39 said:
  
  Wow, that’s a cool tip! I even did not know that something like this exists, very cool!
  
  LikeLike
  
  Reply ↓
Pingback: Installing openHAB Home Automation on Raspberry Pi | MCU on Eclipse
Carlos on December 24, 2015 at 16:19 said:

Hi Erich,
Raspberry Pi, DMA read and write functions similar to ARM?
read (SPI, SCI, GPIO) and write (SPI, SCI, GPIO).
has pin ( trigger_request ).
I looked info in the manual but it was not clear to me.
thanks
Carlos.

LikeLike

Reply ↓
- Erich Styger on December 24, 2015 at 20:16 said:
  
  Hi Carlos,
  I’m sure it has that, but I have not used anything like this on that low level as on other ARM. With using a Linux a lot of the hardware is hidden behind the device drivers.
  Erich
  
  LikeLike
  
  Reply ↓
JJJ on March 1, 2016 at 14:08 said:

You can use two usb port ??

power use 5v pulled on usb equipment

LikeLike

Reply ↓
- Erich Styger on March 1, 2016 at 14:12 said:
  
  You can use it as a USB Gadget, see https://learn.adafruit.com/turning-your-raspberry-pi-zero-into-a-usb-gadget/overview
  
  LikeLike
  
  Reply ↓