Dell Mih61r Mb Front Panel Pinout ◉
You have a Dell OptiPlex 3010, 7010, or 390. The motherboard is the (often labeled CN-0Y8H8Y or similar). You decided to move this motherboard into a standard ATX case to save money, or perhaps you are trying to diagnose a power button failure.
On the Dell MH61R, the power switch circuit is on and Pin 7 (GND) .
You plugged in the standard Intel front panel header connector. You pressed the power button. Nothing happened. Dell Mih61r Mb Front Panel Pinout
| Pin Number | Signal | Description | Standard Intel Equivalent | | :--- | :--- | :--- | :--- | | 1 | HDD LED + | Hard Drive Activity (Anode) | Pin 1 | | 2 | HDD LED - | Hard Drive Activity (Cathode) | Pin 3 | | 3 | GND | Ground | Pin 2 or 4 | | 4 | PWR LED + | Power LED (Anode - Green) | Pin 2 (Usually) | | 5 | PWR LED - | Power LED (Cathode) | Pin 4 | | 6 | PWR_SW | | Pin 6 (Usually) | | 7 | GND | Ground for Power Button | Pin 8 (Usually) | | 8 | NC | Not Connected (Key pin on Intel) | Pin 5 (Missing on Intel) | | 9 | +5V (Standby) | 5V always on | N/A | | 10 | GND | Aux Ground | N/A |
On the MH61R, look for a header labeled or simply FRONT PANEL . It is located near the bottom right edge of the board, usually just above the SATA ports. You have a Dell OptiPlex 3010, 7010, or 390
If you are reading this, you have likely just experienced a specific flavor of PC building frustration.
Press F1 to continue, or flash a modified BIOS (risky) or simply short the two sensor pins together (Pin 8 and Pin 9 in some revisions—research your specific board first). Final Verdict The Dell MH61R is a perfectly capable LGA1155 board (supports Ivy Bridge i5/i7), but it was designed to be e-waste, not upgraded. By understanding the pinout—specifically that the power switch uses Pins 6 & 7 instead of 6 & 8—you can resurrect this board in any case. On the Dell MH61R, the power switch circuit
Let's tear down the schematic, identify the pins, and get your machine booting. On most standard motherboards (Asus, MSI, Gigabyte), the front panel header is a block of 9 pins (missing one for keying). Dell, however, uses a 10-pin or 12-pin header layout that redefines everything.
