Cls-3900 Car Uart <HD – 480p>

import serial ser = serial.Serial('/dev/ttyS0', 9600, timeout=1) while True: data = ser.readline() print(data.decode().strip())

void loop() if (Serial.available()) char c = Serial.read(); // process data cls-3900 car uart

CLS-3900 TX → RPi RX (GPIO 15) CLS-3900 RX → RPi TX (GPIO 14) GND → GND VCC → 3.3V (if supported) Python on Raspberry Pi: import serial ser = serial

CLS-3900 TX → Arduino RX (pin 0) CLS-3900 RX → Arduino TX (pin 1) GND → GND VCC → 5V (if 5V logic) Use GPIO UART (e.g., /dev/ttyS0 or /dev/ttyAMA0 ): import serial ser = serial.Serial('/dev/ttyS0'

void setup() Serial.begin(9600);