Cat-3.5h.gcode -

Works out of the box for Bowden setups, but minor tuning makes it perfect.

This G-code produced a decent cat model on my Ender 3 (0.2 mm layer height, PLA). The print time was accurate at about 3 hours 35 minutes. cat-3.5h.gcode

Here’s a draft review for a file named — I’ve written it as if you’re a 3D printing enthusiast reviewing the G-code (likely for a cat model that takes ~3.5 hours to print). Title: Solid profile, but check your retraction settings File: cat-3.5h.gcode Rating: ⭐⭐⭐⭐☆ (4/5) Works out of the box for Bowden setups,